Message rules FAQs and troubleshooting
Message rules FAQs and troubleshooting
What to check when an automated message doesn't send, or sends at the wrong time.
Automated messages aren't sending
Open the booking and select the Logs tab.
- The message isn't listed. The rule is switched off, doesn't include this listing or booking site, or was switched on after the send time had passed. See "I can't see a message on the log" in Outbound message logs
- It's listed. Hover over its status for the reason. Most reasons say what to do next, and Outbound message logs explains each status and how to resend. The causes below need a change outside the log.
A filter is holding it back
The status shows On hold, then Not sent once we stop checking. How long a message is held is in "What happens when a filter doesn't match" in Automated message filters. To let one booking through, change the booking, not the rule. On the booking's Summary tab:
- Security deposit. Select Mark security deposit as collected or not required, then Confirm not required.
- Rental agreement. Select Mark rental agreement as signed, then Mark as signed.
- Guest identity. Select Mark guest identity as not required, then Confirm guest identity as not required.
Two filters can't be overridden on a booking:
- SafeGuest status never matches a booking with no SafeGuest check.
- Gap night holds the message while the night next to the stay is booked or blocked. If the night is still taken when we stop checking, the message shows Not sent, and there's nothing to resend.
The filters combine differently from what you expect
Check Send when All / Any of the following match on the rule. With All, every filter must match; with Any, one is enough. See Automated message filters
Automated messages are switched off for the booking
If the reason is "Automated messages are switched off for this booking.", switch on Automated messages under Automation settings on the booking's Summary tab. Messages still On hold then send. Messages already Not sent don't: type them on the booking's Messages tab.
The guest's email address is missing or wrong
Use the banner at the top of the Logs tab. See "Fix a missing or wrong guest email" in Outbound message logs.
Messages sent at the wrong time
- The listing's Timezone is wrong.
- The booking's arrival or departure time is wrong. See Arrival and departure times.
Check both on the listing's Details tab, under Basics.

Last-minute guests get the check-in message before the confirmation
You can't set an order between two messages. Instead, send last-minute guests one combined message:
- On the check-in message, leave Send this message to guests who book within the scheduled window before arrival unticked.
- Create one last-minute message with everything in it, and add a Booking lead time filter so it only goes to bookings made later than your check-in message's send time (for example less than 24 hours before arrival).
See "Last-minute bookings" in Automated guest messages and "Booking lead time" in Automated message filters.
FAQs
Why does my message show the year twice?
{check_in_date} and {check_out_date} include the year. Remove any year you typed after the tag. See Message tags.
Do Airbnb bookings pass the Security deposit and Guest identity filters?
Yes, if Uplisting doesn't take a deposit or check ID for the booking: "has been collected or is not required" and "is verified" then count as met. "is not verified" never matches. See Automated message filters.
How can I check a message before it goes out?
Use the preview on the rule. It fills the message in for a booking you choose and flags tags that are empty. See Automated guest messages.
How do I remind guests on a payment plan to pay?
Create a rule that sends a few days before the balance is due, with the filter Booking payment status: is partially paid. See "Payment reminder example" in Automated message filters.
Can I resend a message that didn't go out?
Yes, automated messages, from the booking's Logs tab. See Outbound message logs.
Related articles
Updated on: 19/11/2026
Thank you!
